T-Motor VELOX V50A 3-6S BLHeli_32 4-in-1 ESC

T-Motor VELOX V50A ESC is the ultimate ESC for your build. Adopting the QN3109 1.5 MOS, the V50A has been upgraded with an 18% performance increase to fly in confidence even during high-current spikes.

The brand new cooling fin design makes heat dissipation more efficient and guarantees stable power output. Heat dissipation has increased by 10%.

Velox V50A Features

• Improved Heat Dissipation
• Upgraded MOS
• 50A 4-in1 ESC

• Each time ESC is connected to the system, input throttle signal will be detected automatically when powered on and execute corresponding throttle mode;
• When BLDC motor is connected to the system for the first time, or RC equipment is changed, throttle calibration is required. Please skip throttle range calibration when input signal is Dshot mode.
• Don’t flash any other firmware to avoid ESC damage.
• Please repeatedly check if the polarity and connection sequence are correct before power up. Wrong connection would damage the equipment.
• Please power off first when pluging or making any connections.
• Please using within the range of ESC working current.
• Please use welding equipment with full power and choose right-size welding head. Try to avoid any equipments out of operation or short-circuits damage caused by wrong welding.
• VBAT is battery voltage, if connecting to other equipment, please make sure if the input volt- age is within the range.
• CRT. (Current) is current detection output interface, can connect T-MOTOR F4, F7 or other FC can support current detection.
• If any questions, please contact T-MOTOR after-sales technical support.

Welding tips:

• Don’t add tin wire too much and too fast in welding process in case solder ball spilling out.
• Stick a layer of electrical tape above cooling fin before welding in case tin or other pollutes spotting on fin.
• Please carefully check if there are any tin ball or bonded soldering joint before power up in case equipment damage caused by short-circuit.
• Please use 95% or higher purity alcohol or water when cleaning PCB and don’t squeeze com- ponents and wires much.
  Remedies after water:
• Please power off at first once ESC, FC or other PCBs (including motors) meet water damage, and don’t power on again.
• Clean all clutter and dry with hairdryer.
• Please don’t power on again before making sure there is no water inside any more. Please contact our after-sale service center ASAP.
• If you can see solder joints or burnt traces on components, which means this power section has burned out. Please don’t power on again then lead to further damage.

V50A Specifications

• Mounting Hole: 30.5×30.5mm, M3
• ESC Firmware: TMOTOR T4 02
• Weight: 18.45g (with cable)
• Input Voltage: DC10V~27V
• Parameter: BLHeliSuite32
• Size 45.4×43.8x8mm
• Model: Velox V50A
• Peak Current: 55A
• Current: 50A
• LiPo: 3-6S

Includes

• 1x 50A 32Bit 4-In-1 ESC
• 1x 8P/10P Exchangeable Wiring Harness
• 1x 8P/8P Silicone Wiring Harness
• 1x XT60 14AWG 145mm Cable
• 4x Shock Absorbing Washer
• 1x Capacitor