Mauch Standard Line 100A 2-6S current Sensor (HS-100-LV)
Mauch Standard Line 100A 2-6S current Sensor (HS-100-LV) Current measurement sensor board, based on Allegro Hall Sensor ACS-100U. The voltage reading of the LiPo is optimised for up to 6S LiPo packs. This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section. The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry… etc. Connected to the sensor are 2x10cm AWG12 wire (red) as a standard. The board comes with
- 10cm connection cable (DF-13-6pDF-13-6p) to the FC for Pixhawk 1 or APM.
- Please ensure the correct current flow direction.
- Please install the sensor either with the supplied shrinking tube or with an CFK enclosure for insulation.
- The input voltage should be 5.20-5.35V.
- It is recommended to connect the BEC input wires as close as possible to the main battery.
Required installation space:
31x17x10mm -> PCB only
Setup in MissionPlanner:
Please follow the procedure here: http://ardupilot.org/copter/docs/common-mauch-power-modules.html
Good,Fast Delivery